At Plumbdog we have all the gear and every idea!

Need a plumber? We’ll get your tail wagging again. Plumbing by pedigree plumbers from only $125 across the Greater Perth Region.



Hot Water. Same Day. Guaranteed.

No hot water? Need a replacement or repair? Plumbdog Plumbing Perth has you covered.

Our qualified plumbers can come onsite today. We have a range of new hot water systems available in our Perth warehouse, or if it’s a repair for your existing system that’s required, we carry the parts to get you sorted.

In a worst-case scenario, if the parts you need to get your existing hot water repair completed on the day aren’t available, we’ll set you up with a temporary system so your household hot water is flowing before we go. Then we’ll be back as soon as possible to put in your long-term solution.

Contact your local Plumbdog today!

Just like a car, your hot water system needs regular servicing – not just for optimum performance, but also to minimise the likelihood of a breakdown, which we all know can happen at the worst times.

One of the most common causes of water heater failure is blocked pilot tubes, where spider webs can obstruct the flow of gas.

Thermocouples, which ensure the gas valve remains closed when the system is not in use, have limited service life and must be periodically replaced. Other common problems are blocked line strainers, faulty ignition packs and faulty solenoids.

Regardless of the age or type of system installed, we recommend having it serviced at least once every two years by one of our fully qualified Plumbdog hot water plumbers. To ensure maximum life of your unit, you should also replace its sacrificial anode as part of regular servicing.

Manufacturers recommend you have all of your gas and electric appliances serviced regularly, which includes a regular major service of your hot water system. Our servicing will include the following tests and maintenance tasks:

Gas storage: Clean burner and pilot tube, check/replace thermocouple, test gas valve & thermostat, check inlet and burner pressure, check condition of anodes, test hot and cold relief valves.

Gas instantaneous:  Clean burner and pilot tube, test/replace thermocouple, replace diaphragm and O-rings, check inlet and burner pressure, test solenoids.

Electric storage: Test electrical connection, test thermostat and element, check condition of anodes, test hot and cold relief valves.

Electric instantaneous: Test electrical connection (3 phase power), test thermostat, line strainer and flow switch, test relief valves.

Standard hot water service: As part of your regular hot water service, we will always inspect your unit for both age and condition, with an average time of 30 – 60 minutes on-site. Any parts required will vary in price according to the brand and size of your unit.

If we pick up any faults during our hot water system service, we’ll discuss the next course of action to fix the problem in the most cost-effective way. We keep our service vans fully stocked, so in most cases we can find a solution on the spot. 

If your existing hot water system is beyond repair and must be replaced, we supply and install a range of top brand gas storage and gas instantaneous hot water systems, along with electric instantaneous and electric storage. But don’t worry, we’ll only cross that bridge if we have to.

Make a Booking

Supply & Install Enquiry

Apply for a position form

Upload documents (CV and cover letter)

Contact Us

Enquire Now